Strange Problems Retrieving Saved Projects

Every time i try to open my projects, i get a "Error:errors during loading of the topology file, please correct them. Reset error, lost communication with hypervisor?

What am I doing wrong?

Also..i get the 206-unable to create UDP NIO error when i have two routers and try to connect a serial cable between the two.

But when i try a SECOND time, i can connect them.

THis happens EVERY time.

It wont save my configuration or any settings on my routers (added slots etc)

GNS3 0.8.3 is my current version.

I did notice that it saves when theres just ONE router. I CAN pull up the saved configuration.

BUt when i add another router, thats when i have all of these issues.

The connection lost box comes up and the above posted occurs.

Yet sure enough, when i try to pull up the SINGLE router, fully configured, i have no issues at all.

Router used is the c26291 and the ios is: c2691-adventerprisek9-mz.124-25c.image

Other errors I am receiving:

Dynamips Error:206-unable to extract config of VM R1

Error 206-unable to create UDP NIO when connecting two serial routers together.

Errors: errors during loading of the topology file, please correct them.
Reset error, lost communication with hypervisor?

Exception detected, stopping importation.

anyone figure this out yet? I'm having the same problem...I'd really hate to have to reconfigure a topolgy EVERY TIME i wanna do labs.

Hello Diceflamez and flatman123

I receive the same issues. I remember Jeremy Ciora mentioning this in one of his videos on the cbt ccnp route. You have to select a check box which instrucsts GNS3 to save the configurations, however this has not really worked for me so far, so if anyone can crack this..let us know.

If I do then I'll post the solution :)

Greenhornet.