Dear All,

I have try fellow below site but not successful.

Below is error message.

Link--http://www.freeccnaworkbook.com/workbooks/ccna/configuring-the-free-ccna-workbook-gns3-topology
========= GNS3 0.8.3.1 traceback on 06 Jun 2013 11:34:07 =========
Traceback (most recent call last):
File "GNS3\NETFile.pyo", line 632, in import_net_file
File "GNS3\Dynagen\dynagen.pyo", line 1087, in import_config
File "GNS3\DynagenSub.pyo", line 352, in open_config
File "GNS3\HypervisorManager.pyo", line 182, in waitHypervisor
UnicodeDecodeError: 'utf8' codec can't decode byte 0xb5 in position 14: invalid start byte

Thanks,

Ricky

Hi,

Can you try with GNS3 0.8.4 RC3? Let me know if this work ... or not.

Thanks,

_________________
Jeremy, GNS3 Programmer & Benevolent Dictator for Life.

I downloaded the lastest canidate and cannot import project back into the program. I do a show startup and see the config and then do a reload on all routers but that does not import the config. It leaves me with the "do you want to configure.... yes/no." line.

Need help on what I am doing wrong.

Thanks!!