It is currently Fri Jul 21, 2017 12:43 am


All times are UTC




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: configure Vlan
PostPosted: Tue Sep 02, 2014 9:42 am 
Offline

Joined: Tue Sep 02, 2014 9:31 am
Posts: 1
I'm new to GNS3 and using GNS3 8.7. I tried to configure Vlan with following IOS but it does't give relevant commands to configure Vlan.
it shows only below commands under Vlan menu. Please advice me how to solve this issue.
Router c2691
Router c3640
Router c3725
=================================================
R3#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R3(config)#vla
R3(config)#vlan ?
accounting VLAN accounting configuration
ifdescr VLAN subinterface ifDescr

==================================================




Top
 Profile  
 
 Post subject: Re: configure Vlan
PostPosted: Tue Sep 02, 2014 12:05 pm 
Offline

Joined: Tue Jan 21, 2014 3:17 pm
Posts: 36
Try this:

http://www.gns3.net/documentation/gns3/ ... n-in-gns3/


Top
 Profile  
 
 Post subject: Re: configure Vlan
PostPosted: Tue Sep 02, 2014 3:36 pm 
Offline

Joined: Thu Jul 10, 2014 4:46 pm
Posts: 57
I know you're using different router images, but if you decide to use the "swouter", it uses vlan database mode. And you have to type "exit" when done. Ctrl-Z won't apply the changes.


Top
 Profile  
 
 Post subject: Re: configure Vlan
PostPosted: Sun Sep 21, 2014 10:13 am 
Offline

Joined: Thu Sep 18, 2014 7:33 pm
Posts: 12
Try vlan database on priv mode .
:)


Top
 Profile  
 
 Post subject: Re: configure Vlan
PostPosted: Tue Oct 21, 2014 8:39 am 
Offline

Joined: Tue Oct 21, 2014 8:30 am
Posts: 1
Being that you're actually trying to configure virtual lans in the router, you have to approach it a bit differently. If you work in a switch, the VLAN or the VLAN database (deprecated) commands would be available to you. If you were in a switching module, perhaps then the VLAN or VLAN database commands would also be available to you. However, since you are in a router you don't create VLANs, per se. You create sub interfaces that are looking for the shims or the tags that are inserted into the packets per the VLAN that have been created on the switch.

Perhaps I'm incorrect in the interpretation of what you're asking. But what it appears that what you are trying to do is "routing on a stick". You still configure routing on a stick when you have a switch module inserted into a router. Here's a link that hopefully will give you some insight, information and more illumination on this particular topic.

https://learningnetwork.cisco.com/docs/DOC-23481




Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group

phpBB SEO