It is currently Sun Jul 05, 2020 11:16 pm

All times are UTC

Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: No Crypto isakmp policy in ASA with GNS3
PostPosted: Thu Oct 02, 2014 1:23 pm 

Joined: Thu Oct 02, 2014 1:16 pm
Posts: 1
Hi All,

Did anyone have problems with IPSEC configuring on ASA with GNS3?
I wanna setup IPsec site to site VPN with ASA, but I don't see the crypto isakmp enable/ policy command set at all in config mode?

I am using the ASA version 8.4(2), Mode Single

Help please,
Thanks in advance

ciscoasa# show version

Cisco Adaptive Security Appliance Software Version 8.4(2)

Compiled on Wed 15-Jun-11 18:17 by builders
System image file is "Unknown, monitor mode tftp booted image"
Config file at boot was "startup-config"

ciscoasa up 25 mins 2 secs

Hardware: ASA 5520, 1024 MB RAM, CPU Pentium II 1000 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash unknown @ 0x0, 0KB

0: Ext: GigabitEthernet0 : address is 00ab.a72f.0100, irq 0
1: Ext: GigabitEthernet1 : address is 00ab.a72f.0101, irq 0
2: Ext: GigabitEthernet2 : address is 0000.ab77.9d02, irq 0

Licensed features for this platform:
Maximum Physical Interfaces : Unlimited perpetual
Maximum VLANs : 100 perpetual
Inside Hosts : Unlimited perpetual
Failover : Active/Active perpetual
VPN-DES : Enabled perpetual
VPN-3DES-AES : Enabled perpetual
Security Contexts : 5 perpetual
GTP/GPRS : Disabled perpetual
AnyConnect Premium Peers : 25 perpetual
AnyConnect Essentials : Disabled perpetual
Other VPN Peers : 5000 perpetual
Total VPN Peers : 0 perpetual
Shared License : Enabled perpetual
AnyConnect for Mobile : Disabled perpetual
AnyConnect for Cisco VPN Phone : Disabled perpetual
Advanced Endpoint Assessment : Enabled perpetual
UC Phone Proxy Sessions : 10 perpetual
Total UC Proxy Sessions : 10 perpetual
Botnet Traffic Filter : Enabled perpetual
Intercompany Media Engine : Enabled perpetual

This platform has an ASA 5520 VPN Plus license.

Serial Number: 123456789AB
Running Permanent Activation Key: 0xb23bcf4a 0x1c713b4f 0x7d53bcbc 0xc4f8d09c 0x0e24c6b6
Configuration register is 0x0
Configuration last modified by enable_15 at 13:10:18.129 UTC Thu Oct 2 2014

ciscoasa(config)# crypto isakmp ?

configure mode commands/options:
disconnect-notify Enable disconnect notification to peers
identity Set identity type (address, hostname or key-id)
nat-traversal Enable and configure nat-traversal
reload-wait Wait for voluntary termination of existing connections
before reboot
ciscoasa(config)# crypto isakmp

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC

Who is online

Users browsing this forum: No registered users and 9 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group