GNS3
http://forum.gns3.net/

No Crypto isakmp policy in ASA with GNS3
http://forum.gns3.net/topic12326.html
Page 1 of 1

Author:  Anthony [ Thu Oct 02, 2014 1:23 pm ]
Post subject:  No Crypto isakmp policy in ASA with GNS3

Hi All,

Did anyone have problems with IPSEC configuring on ASA with GNS3?
I wanna setup IPsec site to site VPN with ASA, but I don't see the crypto isakmp enable/ policy command set at all in config mode?

I am using the ASA version 8.4(2), Mode Single

Help please,
Thanks in advance


ciscoasa# show version

Cisco Adaptive Security Appliance Software Version 8.4(2)

Compiled on Wed 15-Jun-11 18:17 by builders
System image file is "Unknown, monitor mode tftp booted image"
Config file at boot was "startup-config"

ciscoasa up 25 mins 2 secs

Hardware: ASA 5520, 1024 MB RAM, CPU Pentium II 1000 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash unknown @ 0x0, 0KB


0: Ext: GigabitEthernet0 : address is 00ab.a72f.0100, irq 0
1: Ext: GigabitEthernet1 : address is 00ab.a72f.0101, irq 0
2: Ext: GigabitEthernet2 : address is 0000.ab77.9d02, irq 0

Licensed features for this platform:
Maximum Physical Interfaces : Unlimited perpetual
Maximum VLANs : 100 perpetual
Inside Hosts : Unlimited perpetual
Failover : Active/Active perpetual
VPN-DES : Enabled perpetual
VPN-3DES-AES : Enabled perpetual
Security Contexts : 5 perpetual
GTP/GPRS : Disabled perpetual
AnyConnect Premium Peers : 25 perpetual
AnyConnect Essentials : Disabled perpetual
Other VPN Peers : 5000 perpetual
Total VPN Peers : 0 perpetual
Shared License : Enabled perpetual
AnyConnect for Mobile : Disabled perpetual
AnyConnect for Cisco VPN Phone : Disabled perpetual
Advanced Endpoint Assessment : Enabled perpetual
UC Phone Proxy Sessions : 10 perpetual
Total UC Proxy Sessions : 10 perpetual
Botnet Traffic Filter : Enabled perpetual
Intercompany Media Engine : Enabled perpetual

This platform has an ASA 5520 VPN Plus license.

Serial Number: 123456789AB
Running Permanent Activation Key: 0xb23bcf4a 0x1c713b4f 0x7d53bcbc 0xc4f8d09c 0x0e24c6b6
Configuration register is 0x0
Configuration last modified by enable_15 at 13:10:18.129 UTC Thu Oct 2 2014


ciscoasa(config)# crypto isakmp ?

configure mode commands/options:
disconnect-notify Enable disconnect notification to peers
identity Set identity type (address, hostname or key-id)
nat-traversal Enable and configure nat-traversal
reload-wait Wait for voluntary termination of existing connections
before reboot
ciscoasa(config)# crypto isakmp

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/