GNS3
http://forum.gns3.net/

Problema executar vpcs in simple scenario
http://forum.gns3.net/topic11110.html
Page 1 of 1

Author:  gidelberto [ Mon Jul 21, 2014 3:35 pm ]
Post subject:  Problema executar vpcs in simple scenario

I have installed GNS3 0.8.7 in full mode. I created a simple scenario with 2 PC connected to switch 1. When I try to enter VPCs tools, gives error. When it does not error, I set up and these PCs fail to ping the other computer. What can this be, or what is wrong.

configuration of pc's
pc1 ip 192.168.1.1 24
pc2 ip 192.168.1.2 24

Thank you. Gibs

Author:  rednectar [ Tue Jul 22, 2014 10:45 pm ]
Post subject:  Re: Problema executar vpcs in simple scenario

The most common error with VPCS is caused by the fact that the VPCS window can only be opened once, and it must be closed before it can be opened again. Unfortunately, this applies even if you quit and open GNS3 again.

So if you see output like:
Code:
Open port 20000 error [Address already in use]
Open port 20001 error [Address already in use]
Open port 20002 error [Address already in use]
Open port 20003 error [Address already in use]
Open port 20004 error [Address already in use]
Open port 20005 error [Address already in use]
Open port 20006 error [Address already in use]
Open port 20007 error [Address already in use]
Open port 20008 error [Address already in use]


Then you have another VPCS window open - go and close it first, then try again. I suggest you read my VPCS Tutorial and try again.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/