Rapid Juniper Lab config
Page 1 of 1

Author:  hrtendrup [ Wed Oct 24, 2012 2:44 am ]
Post subject:  Rapid Juniper Lab config

So, when studying for certs or testing out some design, I feel it's an inefficient use my time to go through and address links, set up IGPs, put appropriate address families on interfaces, etc. So, I built a set of scripts that builds some of the basics for me.

It's not bullet proof and the documentation assumes knowledge of GNS3, Olive, and some Perl, but if you have a bit of time to play with it, I think you'll be able to figure it out.

File comment: Perl scripts + documentation [1.03 MiB]
Downloaded 390 times

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group