EIGRP Configuration, Bandwidth, and Adjacencies
Page 1 of 1

Author:  kansukre [ Mon Mar 09, 2009 9:29 pm ]
Post subject:  EIGRP Configuration, Bandwidth, and Adjacencies

Learning Objectives
• Configure EIGRP on an interface
• Configure the bandwidth command to limit EIGRP bandwidth
• Verify EIGRP adjacencies
• Verify EIGRP routing information exchange
• Utilize debugging commands for troubleshooting EIGRP
• Challenge: Test convergence for EIGRP when a topology change occurs

You are responsible for configuring the new network to connect your company’s
Engineering, Marketing, and Accounting departments, represented by the
loopback interfaces on each of the three routers. The physical devices have just
been installed and are connected by Fast Ethernet and serial cables. Your task
is to configure EIGRP to enable full connectivity between all departments.

EIGRP.PNG [ 162.01 KiB | Viewed 6493 times ]
EIGRP Configuration, Bandwidth, and Adjacencies.rar [5.76 KiB]
Downloaded 1677 times
EIGRP.rar [675 Bytes]
Downloaded 1383 times

Author:  geamella [ Wed Feb 08, 2012 7:28 am ]
Post subject:  Re: EIGRP Configuration, Bandwidth, and Adjacencies

How can I monitor bandwidth usage on a network, per computer? I need to see how much bandwidth is being used by any computer at any point in time. I have about 15 workstations and about 4 servers on a broadband connection, problem is we keep spiking and reaching our cap. I don't know where exactly the spike in usage is coming from.
yahoo keyword tool ~ overture ~ traffic estimator ~ adwords traffic estimator

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group