GNS3
http://forum.gns3.net/

Can't connect / bridge multiple routers with host PC / OSX
http://forum.gns3.net/topic10864.html
Page 1 of 1

Author:  micko [ Wed Jul 09, 2014 4:12 am ]
Post subject:  Can't connect / bridge multiple routers with host PC / OSX

Hi, I am running GNS3 on OSX 10.9 and would like to connect (bridge) multiple routers with host PC
so I can access the routers directly with my home network. Basically I want to create a scenario similar
to when adding Generic NIO to the cloud and thus allowing me to access the specific router directly,
unfortunately this scenario allows for only a single router. Host PC is iMac using WiFi.

I am looking at two different scenarios:

#1: adding an "Ethernet switch" and connecting one port to the cloud using Generic NIO - not working.

#2: adding multiple TAP devices to the cloud and adding them to a bridge with eng1 - multiple routers
can communicate between themselves but not with Host PC.


Help! :)

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/