Gns3 1.0 ER ?
Page 1 of 1

Author:  flower_01 [ Sat Sep 20, 2014 6:10 am ]
Post subject:  Gns3 1.0 ER ?

I am using the recent version of the Gns3. There i am getting the problem with the new version. High CPU utilization and the Router names can't be changing, one more thing is when copied idle pc values from older version of the gns3. it will also not working. Here i am attaching the screen shot for my errors
kindly give the solution for the next version of the GNS3.

Thank you.

File comment: High CPU Utilization and the router names can't be changing..
GNS3-ER3.jpg [ 252.46 KiB | Viewed 11228 times ]

Author:  rlouarn [ Sat Sep 27, 2014 11:36 am ]
Post subject:  Re: Gns3 1.0 ER ?


Not sure that my answer will help you, but hopefully it will...

To change the name of a router, you must have your router powered off (compulsory), than right click on it, select configure and then click on the actual router name (R1 for example). There, you should be able to configure the name, as well as other parameters (image, slots,...).

For the idle-pc, I would recommand to run it again router by router (only one at a time) and try different values, you should find one that will give you less than 1% usage (make sure that your CPU usage is null or very low before running any router). Don't use values from previous version of GNS3, the dynamips has been updated, it could behave differently I suppose.


Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group