GNS3
http://forum.gns3.net/

Unable to load the router
http://forum.gns3.net/topic3512.html
Page 1 of 1

Author:  civokruk [ Wed May 04, 2011 8:00 pm ]
Post subject:  Unable to load the router

Hi
I am new to the forum. I have downloaded the software and installed it a Mac. I did the configuration but I am unable to load the router into the interface. When I drag the router to the interface I get " Please register a least one IOS ..."
Please help

Author:  rednectar [ Thu May 05, 2011 11:34 am ]
Post subject:  Re: Unable to load the router

Congratulations on getting GNS3 installed on a Mac! Not as easy as other platforms.

Although written for PCs and Linux, and based on an old version of GNS3, you will find out about the concepts if you read the tutorial at http://downloads.sourceforge.net/gns-3/ ... torial.pdf (where it will tell you how to set up GNS3 with IOS images which is your problem)

If you have VMware Fusion on your Mac you can also run GNS3 as a Virtual Machine - you'll find a link to a ready-made VM in my signature, but like any installation of GNS3 you will have to find a Cisco IOS image to use with that as well.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/