GNS3
http://forum.gns3.net/

Juniper interfaces in GNS3 not matching what's in the router
http://forum.gns3.net/topic10502.html
Page 1 of 1

Author:  hikerguy [ Mon Jun 16, 2014 4:45 pm ]
Post subject:  Juniper interfaces in GNS3 not matching what's in the router

I created a Junos image and it boots just fine. The problem I'm having is the interfaces in GNS3
don't match what's in the router.

I connected two interfaces together and conntected them using what GNS3 says is an e0 interface. Howver, when I log into these routers, I don't see an e0 interface. I DO see interfaces em0 - em5. If I do "show int em0", it says it's an Ethernet interface. I tried shutting down the interface in one of the routers, and it shows it down down. However, when I go back to GNS3, it still shows both interfaces green, and when I log into the router that's attached to the interface I just shut down, it still shows up.

So, am I doing something wrong, or is this a quirk with GNS3 (or the Juno images)?

Thanks,

Andy

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/