It is currently Sat Jul 04, 2020 11:46 am

All times are UTC

Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Controller commands in emulated routers
PostPosted: Mon Sep 19, 2011 11:39 am 

Joined: Wed Feb 02, 2011 6:13 am
Posts: 3
Hi experts,

First of all, let me thank to the developers (Geremy and others) of GNS3. They are simply great and genius people I've ever seen!!!

I'm not a programmer or nor a person who has a fare idea of programming. Pardon me if I've said anything stupid.. Just a little query.. There is no command like "controller E1 or T1 " in any of the router model!

After searching over the net, I found that 3800 series routers by default support those commands, later I learnt that other routers could support as well the "controller E1 " command if there is specific hardware e.g. "NM-CE". Is that possible to integrate this feature of Cisco Routers ?? Usually , I use GNS3 to simulate my Vendor Network segment and directly copy paste the config afterwards. Recently, I'm stuck with such kind of configuration e.g. "int serial 0/0:0 or controller commands"

Again I would like to express my gratitude to the developers.

Thanks & Regards

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group