GNS3
http://forum.gns3.net/

How To Factory Reset -- Cisco switch
http://forum.gns3.net/topic7915.html
Page 1 of 1

Author:  hi_gns3 [ Fri Dec 13, 2013 6:59 am ]
Post subject:  How To Factory Reset -- Cisco switch

Hi everyone!
What is the best way for restore devices to their default configurations? I got two units of cisco WS-C2960S-24TS-L, but they have configure files and vlan configure, so I want to reset them.I want to simulate this situation on gns3. May I get it?
I know these:
- use the erase startup-config command
- use the config-register 0x2102 command in global configuration mode

Author:  rednectar [ Fri Dec 13, 2013 11:20 am ]
Post subject:  Re: How To Factory Reset -- Cisco switch

It's more complicated than that on GNS3 because your define a startup file int Edit | IOS images and hypervisors - here you specify a startup file. If you want to simulate real devices, create a startup file that has just one command:

Code:
do setup


then specify THAT file as the startup file

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/