Page 1 of 1

Author:  Kanstantsin [ Sat Mar 15, 2014 8:30 am ]
Post subject:  Router

Hello. Why all FastEtherne ports always up/up "FastEthernet0/0 is up, line protocol is up" . Serial interfaces work correctly. If I delete link between routers or router switch line protocol is up. How to fix it? –°omplete reinstallation did not help.

Author:  abort [ Sat Mar 15, 2014 4:16 pm ]
Post subject:  Re: Router

I'm not guru here (neither dynamips nor gns3), but I have some ideas regarding that.
Try to read my post at post26372.html#p26372 and apply to your question.
You will - probably - get the answer.

Author:  Kanstantsin [ Sun Mar 16, 2014 8:52 am ]
Post subject:  Re: Router

Thanks, but the problem remained. Previously, everything worked well, but then the problems started

Author:  claydon_dan [ Sun Mar 16, 2014 11:21 am ]
Post subject:  Re: Router

The problem is dynamips doesn't emulate the physical layer of the router, there is has no way of working out whether the cable is plugged in or not... So the line protocol will always be up.

This only applies to ethernet connections, not serial.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group