|Page 1 of 1|
|Author:||flower_01 [ Tue Sep 04, 2012 10:12 am ]|
|Post subject:||switching issue|
Hi every body can any one solve my issue. How to assign the trunk links to to separate vlans. I used this command,
enter the trunk port, then #switchport trunk native vlan 10, is this right or wrong. if it is right? when i enter the command like show vlan brief, the the trunk vlans are not displaying.
How to view the trunk assigned vlans. i am confusing this issue..
Thanks in advance.
|Author:||RobertE [ Wed Sep 19, 2012 1:46 am ]|
|Post subject:||Re: switching issue|
Native VLAN 10 means any untagged traffic coming across the trunk should be sent to VLAN 10.
The command you want is sh int trunk
Cat3550#show interfaces trunk
Port Mode Encapsulation Status Native vlan
Fa0/17 trunk 802.1q other 1
Fa0/18 trunk 802.1q other 1
Fa0/19 trunk 802.1q other 1
Port Vlans allowed on trunk Fa0/17 1-4094 Fa0/18 1-4094
Port Vlans allowed and active in management domain Fa0/17 1-3,10 Fa0/18 1-3,10
Port Vlans in spanning tree forwarding state and not pruned
|Page 1 of 1||All times are UTC|
|Powered by phpBB® Forum Software © phpBB Group