spanning tree with router Cisco 3640
Page 1 of 1

Author:  jacthemanus [ Mon Jun 03, 2013 4:00 am ]
Post subject:  spanning tree with router Cisco 3640

I am simulating my router as a layer 3 switch (configure slot with NM-16ESW). I have vlan10 and vlan25 and I am trying to check my spanning tree configuration. I don't see any statement in my config file like "spanning-tree mode pvst" like in the real switch. All the ports are in the forwarding state. Do I have to enable the spanning-tree? If yes how? Thanks

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group