GNS3
http://forum.gns3.net/

Switchport port security command doesn't work
http://forum.gns3.net/topic7175.html
Page 1 of 1

Author:  Router47 [ Fri Oct 04, 2013 12:03 am ]
Post subject:  Switchport port security command doesn't work

I don't know if it's just the EtherSwitch Router or this version of GNS3 or GNS3 in general but the commmand:


R1-SW(config)#interface _________ _/_
R1-SW(config-if)#switchport port-security
R1-SW(config-if)#switchport port-security ________________ (mac-address, maximum, or violation)


doesn't work


anybody else having this issue?


could it be because i'm NOT in "Trunk" mode for both Administrative and Operational Mode?


just wondering

Author:  abort [ Fri Oct 04, 2013 7:09 am ]
Post subject:  Re: Switchport port security command doesn't work

With NM-16ESW you can play with LIMITED number of switching features.
But, port-security is not supported with NM-16ESW (routers equipped with NM-16ESW).

List of NOT SUPPORTED features is available at http://www.gns3.net/hardware-emulated/ (search for "Cisco Catalyst Switches").

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/