It is currently Tue Jun 18, 2019 1:02 am


All times are UTC




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Cannot Console to Juniper Router after connection made
PostPosted: Wed Feb 01, 2012 4:36 pm 
Offline

Joined: Fri Jan 13, 2012 9:04 pm
Posts: 13
I am able to drag and drop a Juniper router into the topology in GNS3, power it on and log into it. However, if I drag and drop another device into the topology, a Cisco or another Juniper router, and make a connection between them, then power them both on, I am not able to bring up the console on the Juniper router. This doesn't seem to impact any Cisco router though, I can console into them even after I make a connection between devices. What could the issue be?

Also, I watched the olive configuration videos, and it looks like the -nographic qemu option is active, how is that done? I tried putting -nographic in the qemu options under qemu->JunOS tab, but it doesn't seem to work.




Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group

phpBB SEO