GNS3 http://forum.gns3.net/ |
|
Cannot Console to Juniper Router after connection made http://forum.gns3.net/topic4558.html |
Page 1 of 1 |
Author: | B22 [ Wed Feb 01, 2012 4:36 pm ] |
Post subject: | Cannot Console to Juniper Router after connection made |
I am able to drag and drop a Juniper router into the topology in GNS3, power it on and log into it. However, if I drag and drop another device into the topology, a Cisco or another Juniper router, and make a connection between them, then power them both on, I am not able to bring up the console on the Juniper router. This doesn't seem to impact any Cisco router though, I can console into them even after I make a connection between devices. What could the issue be? Also, I watched the olive configuration videos, and it looks like the -nographic qemu option is active, how is that done? I tried putting -nographic in the qemu options under qemu->JunOS tab, but it doesn't seem to work. |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |